The register is controlled by an Adjust bit. When the Adjust bit is zero, default values for the settings in that segment are used by the PLL. These default values are also returned upon a register read. The default values are subject to change.
Writing this register to 0 resets the register to its factory defaults.
Fout =6*Fin = 98.304 MHz
6*Fin = 147.456 MHz
15 |
14 |
13 |
12 |
11 |
10 |
9 |
8 |
7 |
6 |
5 |
4 |
3 |
2 |
1 |
0 |
Eight pins support general-purpose I/O to registers that control them.
Table B-7 lists the Peripheral Device Control Register Space for GPIO Control registers:
Table B-7. GPIO Control Registers
Register Name |
Description |
PCI Address |
USB Address |
DSP I/O Page |
DSP I/O Address |
GPIOCFG |
GPIO Configuration Direction Control (1 = input, 0 = output) |
0x010 |
0x0010 |
0x00 |
0x10 |
GPIOPOL |
GPIO Polarity Inputs: 0 = active high 1 = active low. Outputs: 0 = CMOS 1 = Open Drain |
0x012 |
0x0012 |
0x12 |
|
GPIOSTKY |
GPIO Sticky: 1 = sticky, 0 = not sticky |
0x014 |
0x0014 |
0x00 |
0x14 |
GPIOWCTL |
GPIO Wake Control 1 = wake-up enabled (requires sticky set) |
0x016 |
0x0016 |
0x00 |
0x16 |
GPIOSTAT |
GPIO Status Read = Pin state Write: 0 = clear sticky status, 1 = no effect |
0x018 |
0x0018 |
0x00 |
0x18 |
GPIOCTL |
GPIO Control (w), Init (r) Read = Power-on state; Write: Set state of output pins |
0x01A |
0x001A |
0x00 |
0x1A |
Table B-7. GPIO Control Registers (Continued)
Register Name |
Description |
PCI Address |
USB Address |
DSP I/O Page |
DSP I/O Address |
GPIOPUP |
GPIO Pullup Pull-up enable (if input): 1 = enable, 0 = Hi-Z |
0x01C |
0x001C |
0x00 |
0x1C |
GPIOPDN |
GPIO Pulldown Pull-down enable (if input): 1 = enable, 0 = Hi-Z |
0x01E |
0x001E |
0x00 |
0x1E |
G PIO C onfig ura tion (G PIO C FG ) Re g iste r ! This register resets to 0x7F.
15 |
14 |
13 |
12 |
11 |
10 |
9 |
8 |
7 |
6 |
5 |
4 |
3 |
2 |
1 |
0 |
G PIO Pola rity (G PIO PO L) Re g iste r ! This register resets to 0xFF.
15 |
14 |
13 |
12 |
11 |
10 |
9 |
8 |
7 |
6 |
5 |
4 |
3 |
2 |
1 |
0 |
G PIO Stic k y (G PIO STKY ) Re g iste r ! This register resets to zero.
Уважаемый посетитель!
Чтобы распечатать файл, скачайте его (в формате Word).
Ссылка на скачивание - внизу страницы.